ADC H2TU-C-231 PROVISIONING TASKS, Setting Date and Time, Date and Time

LTPH-UM-1109-01, Issue 1Provisioning

		Table 4. Logon Screen Menus (Continued)
Press this	To access this	Menu Functions
key:	menu:
R	Rlogon/Rlogout	Remote logon can be performed from the H2TU-C or H2TU-R. The screen displays “Rlogout”
		when the H2TU-C or H2TU-R is remotely logged on to the other unit at the end of the circuit.
		Remote logon from the H2TU-C will permit viewing of the H2TU-R and BERT Signal
		Generator configuration submenu.
		To log off from the remote unit, press R . “Rlogout” changes to “Rlogon”. The unit is now
		locally logged on until R is pressed again to re-initiate the remote logon.
H	Help	Provides a glossary of terms used in the maintenance screens, a list of navigational keys, and
		ADC contact information.

PROVISIONING TASKS

After H2TU-C-231 is successfully installed, perform these basic provisioning tasks.

•Set date and time (see “Setting Date and Time” below)

•Set circuit ID numbers (see “Setting Circuit ID Numbers” on page 14)

•Make any necessary configuration changes (see “Configuring the System” on page 15)

•Clear history, alarm, and event log screens to remove miscellaneous data during startup (see “Clearing the History, Alarm, and Event Log Screens” on page 23)

Setting Date and Time

Monitor	Performance Event Log	Config	Inventory	Report Rlogon		Help
+		----------------------			+
		Standard Options		->
		ADC Options		->
		BERT	Generator	->
		Date	and Time	->

+-------------------------------		+
Date (mm/dd/yyyy):	05/15/2001
Time (hh:mm[:ss]): 12:30:01
+-------------------------------		+

ID: xxxx--xxxx—-xxxx--xxxx 09/01/2001 12:30:01 H2TU-C System: OK___

Figure 4. Config Menu - Date and Time

1Press C to select the Config menu.

2	Use the ↑ and ↓ arrow keys to select Date and Time, then press ENTER .
3	Type the date in the format indicated, then press ENTER .

H2TU-C-231 List 2 January 9, 2002 13