Provisioning | |
|
|
Configuring the System
The Config menu (Figure 6) allows you to make the following types of system configuration changes:
•Standard options (Figure 7 on page 16)
•ADC options (Figure 8 on page 16)
•BERT Generator (Figure 29 on page 52)
•Date and time (see “Setting Date and Time” on page 13)
•Master clear (see “Clearing the History, Alarm, and Event Log Screens” on page 23)
•Reset to factory default configuration (see “Resetting to Factory Default Values” on page 10)
Monitor | Performance Event Log | Config | Inventory | Report Rlogon | Help | |
+ |
| + |
| |||
Standard Options |
| |||||
ADC Options |
| |||||
BERT | Generator |
| ||||
Date | and Time |
| ||||
Master Clear |
|
| ||||
| Set Factory Defaults |
| ||||
+ |
| + |
| |||
ID: | 09/01/2001 12:30:01 | System: OK___ |
Figure 6. Config Menu
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 16 show the Standard and ADC configuration options. Standard options are those supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an extended set of options that are only available when using HiGain HDSL2 units exclusively. For a description of each option and a list of possible option settings, refer to Table 5 on page 17 and Table 6 on page 18. To make changes to these options:
1Press C to select the Config menu.
2 Use the ↑ and ↓ arrow keys to select Standard Options or ADC Options, then press ENTER .
3Use the arrow keys to select an option.
4Press the SPACEBAR to cycle through the available settings for that option.
5Press ENTER to activate your choice.
January 9, 2002 | 15 |