STEP 3 - MODIFY CONFIG.SYS
MonitorMouse for OS/2 is installed by commands in CONFIG.SYS. Use your system editor to make these changes. In general, the changes are as follows:
1.
2.Add a DEVICE command for the appropriate MonitorMouse for the OS/2 touchscreen driver immediately after the
3.Add a new DEVICE command for MOUSE.SYS.
The order of the DEVICE commands is important. Other changes may be required depending on your hardware configuration and version of OS/2.
Serial Touchscreen Controller on PC Bus System
Change your CONFIG.SYS file as follows:
Rem C:/OS2\MOUSE.SYS {Flags}
Device=c:\elo\monmou01.sys <controller>, <COM port>,<baud rate>
Device=c:\os2\mouse.sys stype=elomou$ {Flags - keep same as above}
Where:
<controller> is:
2300 for the IntelliTouch
4002 for the IntelliTouch
2210 for the AccuTouch
140 for the AccuTouch
<COM port> is:
the number of the COM port where the serial output of the touchscreen controller is connected.
<baud rate>
matches the switch or jumper settings on the controller.
Chapter 10 | Touchscreen | 135 |
