Advantech PPC-150 manual When you install a new CPU, be sure to adjust

10.Connect the power cable of the CPU fan to the 2-pin connector (J12).

11.After changing the CPU, you must set jumpers, including those for the PCI bus clock (JP8), system/PCI clock (JP11), frequency ratio (JP14), and voltage (JP13). (See Section 5.2.)

12.To remove the CPU, pull the lever out to the side a little and raise it as far as it will go. Lift out the CPU chip.

NOTE!	When you install a new CPU, be sure to adjust the
	board jumper settings. Improper settings may damage
	the CPU. (See Chapter 5 for jumper settings.)

CPU fan

Heat sink clip

Heat sink

CPU

Lever

Socket 7

Figure 4-3: Installing the CPU

Chapter 4 Hardware Installation and Upgrading 39