AEG 1.04 manual

UPS OPERATING INSTRUCTIONS

PROTECT 1. M

PROTECT 1.040

Contents

UPS OPERATING INSTRUCTIONS Page 1Notes on these Operating Instructions Duty to provide information Please read these instructions carefully prior to commissioning Validity Warranty and liability Handling Hotline Copyright Table of Contents Page 2 Introduction 2.1Product description Page Page Technical Data UPS output Battery Communication General data Directives Warning: 3 Safety Regulations 3.1Important Instructions and Explanations 3.2Accident Prevention Regulations 3.3Qualified Personnel 3.4Safety Instructions for PROTECT 1.M Page Danger! Electric shocks Only authorised persons are allowed in the vicinity of the batteries Danger! Explosive 3.5CE certificate 4 Set-up 4.1Unpacking and Inspection Page 4.2Transport to Installation Site 4.3Set-Up 5 External View 5.1Front and Rear View of PROTECT 1.M (chassis) 5.2Front/Rear and 3D View PROTECT 1.040 (UPS module) Front and Rear View 5.4Front View of LCD Panel 5.5Display Panel 6 Installation 6.1Installation Notes Note: Page Page 6.2Set-upand Installation of the Modules Page 7 Adding/Removing Modules 7.1Active Redundancy 7.2Installing and Removing UPS Modules 7.2.1Basic procedure for installing a PROTECT 1.040 UPS module 7.2.2Basic procedure for removing a PROTECT 1.040 UPS module 8 Operating and Maintenance 8.1Operation Page Start-up 8.1.2Shutting down 8.1.3 Inquiries 8.1.4Setup (press ESC to exit the aforementioned menus) Page 8.2Maintenance 8.3Shutdown and UPS Management Software 9 Communication Interfaces 10Troubleshooting and Fault Rectification 11Reference Table for the Display and UPS Operating Problems 11.1 Normal operation 11.2Battery Operation 11.3Bypass Operation Warning Signal if Battery System Not Connected 11.5Warning Signal for Phase Loss or Phase Sequence Error 11.6Overload Protection 12 Minimum Number of Battery Packs Page Page 13 List of terms 13.1Technical terminology Page Page Page Page Guarantee Certificate