7.2.1Basic procedure for installing a PROTECT 1.040 UPS module

1.Remove the slot cover cap from the rack in which the UPS module is going to be installed.

2.Grip the UPS module at the sides with both hands. The black dots on the top of the UPS module serve as orientation marks for where to position your thumbs in order to have the centre of gravity in the optimum position. Slowly and carefully push the module into the housing slot. Make sure that the warning notice is facing upwards.

3.Make sure that the module has been completely pushed into the shaft and has clipped in with a clearly audible "click".

4.Reinstall the cover plate.

7.2.2Basic procedure for removing a PROTECT 1.040 UPS module

1.Remove the slot cover cap from the rack from which the UPS module is going to be removed. Use both hands to pull the handles on the sides. Pull until you see the "●" markings on the top of the UPS module you are pulling out (the handle has a detent position, and only when the lever is pressed is it possible to pull the module out).

2.Then hold the module with both hands with your thumbs at the "●" markings and pull it out.

Note: Pull the module slowly and without exerting too much force. In particular, watch out for the shift in the centre of gravity when the module leaves the slot!

34