Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Moving the Range
The range is very heavy. Take great care.
We recommend two people maneuver the range. Ensure that the floor covering is firmly attached, or removed to prevent it being disturbed when moving the range around. You will need the leveling tool.
Pull the drawer out to its furthest point.
Lift up the ends of the plastic clips (one each side) to release the catches holding the drawer to the side runners and at the same time pull the drawer forward and away from the side runners. For safety’s sake push the drawer runners back out of the way. Put the drawer somewhere safe - do not refit it until you have completed the installation, you will need access to the area behind the drawer.
Fit the leveling tool on the rectangular adjuster as shown below.
LOWER THE FRONT ROLLER by doing 14 complete (360°) turns clockwise. (This means turning and removing the leveling tool 56 times).
Now LOWER THE TWO REAR ROLLERS.
First fit the leveling tool on the hexagonal adjusting nut as shown below.
Make 10 complete (360°) turns clockwise. (This means turning and removing the leveling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are two adjusting nuts, one for each roller, at both the front bottom corners of the range.
Note the rollers are only intended to aid installation - the range should not be moved once it is installed.
Push the range close to its final position, leaving just enough space to get behind it.
Do not refit the storage drawer yet
IMPORTANT!
Remove all tape and packaging. Take the accessory pack out of the oven. Check to be sure that no range parts have come loose during shipping.
35
