Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
The neutral or ground wire of the power cord must be connected to the neutral terminal located in the center of the connector block. The power leads must be connected to the outside terminals.
Make sure the connections are tight. Now tighten the stain relief device to clamp the power cord.
Refit the electrical connection cover
3-Wire Conduit Installation
Disconnect the supplied power cord from the terminal block and ground post. Keep the terminal block parts; you will need them. Remove the strain relief clamp from the power cord and remove the power cord and strain relief clamp from the mounting bracket.
The range is shipped with reducer plates to give a 1 1/8’’ diameter opening for conduit connection. Find the reducer plates in the miscellaneous parts pack and fit them to the mounting bracket.
Fit a squeeze connector (not supplied with the range), to your conduit. Insert the conduit through the reducer plates on the mounting bracket. Allow enough slack to easily attach the wires to the terminal block.
NOTE: Do not install the conduit without a squeeze connector.
A Ground Strap is supplied in the miscellaneous parts pack.
ground strap. (grey)
Fit the Ground strap to the ground and center terminal of the connector block - see the figure.
The neutral or ground wire of the power cord must be connected to the neutral terminal located in the center of the connector block. The power leads must be connected to the outside terminals.
NOTE: Make sure the wires are completely inserted into the terminals and secure connections are made.
Secure the squeeze connector in place in the bracket by tightening the squeeze connector screws.
Seal the Openings
Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.
When all Connections are Completed
MAKE SURE THE FLOW OF VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.
39
