Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
| Fitting a |
Disconnect the supplied power cord from the | Disconnect the supplied power cord from the |
terminal block and ground post. Keep the terminal | terminal block and ground post. Keep the terminal |
block parts; you will need them. Remove the strain | block parts; you will need them. Remove the strain |
relief clamp from the power cord and remove | relief clamp from the power cord and remove |
the power cord and strain relief clamp from the | the power cord and strain relief clamp from the |
mounting bracket. | mounting bracket. Discard the strain relief clamp. |
The range is shipped with reducer plates to give a 1 | NOTE: Do not install the power cord without a |
1/8’’ diameter opening for conduit connection. Find | strain relief - use the clamp supplied with the |
the reducer plates in the miscellaneous parts pack | cord. |
and fit them to the mounting bracket. |
|
| Fit the new strain relief device to the mounting | |
| bracket by removing the two clamping screws, | |
Fit a squeeze connector (not supplied with the | feeding the two halves (ears first) through the hole | |
range), to your conduit. Insert the conduit through | in the mounting bracket and loosely refitting the | |
the reducer plates on the mounting bracket. Allow | screws. Insert the power cord through the strain | |
enough slack to easily attach the wires to the | relief device but do not tighten the device yet. | |
terminal block. | A Ground strap is supplied |
|
NOTE: Do not install the conduit without a squeeze |
| |
in the miscellaneous parts |
| |
connector. | pack. | ground strap. (grey) |
| Fit the Ground strap to the ground and center | |
| terminal of the connector block - see the figure. |
Fit the wires to the ground post and terminal block.
NOTE: Make sure the wires are completely inserted into the terminals and secure connections are made.
Secure the squeeze connector in place in the bracket by tightening the squeeze connector screws.
Refit the electrical connection cover.
38