Chapter 4 Remote Interface Reference
System-Related Commands
87
4
*RST
Reset the power supply to its power-on state. The table below shows the state
of the power supply after a RESET from the Recall menu or *RST command
from the remote interface.
Note: The voltage and current step sizes listed above are typical value.
Command E3640A
state
E3641A
state
E3642A
state
E3643A
state
E3644A
state
E3645A
state
CURR 3 A 0.8 A 5 A 1.4 A 8 A 2.2 A
CURR:STEP 0.052 mA 0.015 mA 0.095 mA 0.026 mA 0.152 mA 0.042 mA
CURR:TRIG 3 A 0.8 A 5 A 1.4 A 8 A 2.2 A
DISP ON ON
OUTP OFF OFF
OUTP:REL OFF OFF
TRIG:DEL 00
TRIG:SOUR BUS BUS
VOLT 0 V 0 V
VOLT:STEP 0.35 mV 1.14 mV 0.38 mV 1.14 mV 0.35 mV 1.14 mV
VOLT:TRIG 0 V 0 V 0 V 0 V
VOLT:PROT 22.0 V 66.0 V 22.0 V 66.0 V 22.0 V 66.0 V
VOLT:PROT:STAT ON ON
VOLT:RANG P8V (Low) P35V (Low) P8V (Low) P35V (Low) P8V (Low) P35V (Low)