Getting Started | ESG Family Signal Generators |
Saving and Recalling an Instrument State |
|
Saving an Instrument State
1.Press Save followed by the
Select Seq softkey.
2.Enter 1 using the numeric keypad and press the Enter softkey.
3.Press the Select Reg softkey.
4.Enter 1 using the numeric keypad and press the
Select Reg softkey.
5.Press the SAVE Seq[1] Reg[01] softkey.
The sequence number becomes the active function. The signal generator displays the last sequence that you have used.
This sets the sequence number to 1. (You can also use the arrow keys to enter the sequence number.)
The register number in sequence 1 becomes the active function. The signal generator either displays the last register used [accompanied by the text: (in use)] or, if no registers are in use, displays register 00 [accompanied by the text: (available)].
This selects register 01. (You can also use the arrow keys to select the register number.)
The current instrument settings, including the frequency, amplitude, and modulation changes you made, have been stored in the signal generator memory.
Recalling an Instrument State
1.Press Preset.
2.Press Recall.
3.Press the RECALL Reg softkey.
4.Enter 1 using the numeric keypad and press the Enter softkey.
This sets the signal generator to its
Notice that the Select Seq softkey shows sequence 1. (This is the last sequence that you used.) You do not need to change the sequence.
The register to be recalled in sequence 1 becomes the active function.
Notice that your stored instrument settings have been immediately recalled. (You can also use the arrow keys to select the register number.)
Quick Start Guide |
