Raven and PinPoint CDMA User Guide Version 1.12

AirLink Communications, Inc. Page 7 March 24, 2004
8. Type AT followed by [Enter]. You should receive an "OK" in response.
9. Type ATI1 followed by [Enter]. This displays the modem firmware version
and you should also see "AirLink Communications, Inc." in it which ensures
you are talking to the Raven CDMA modem. (If not, try changing COM
ports.)
Other AT commands may now be issued to the modem. See Section 5 for a list of AT
commands

3.2 Modem Activation

The Raven CDMA modem is usually already set up to register online with a phone
number, etc. pre-configured into it (by AirLink Communications, Inc.). When a
modem is registered on the network and working, the lights will look like the
following:
Note that the RSSI light may be flashing or solid, showing the strength of the signal.
Also the Tx (transmit) and Rx (receive) lights will flash as data is transferred to and
from the modem on the network.
If your modem lights look like the above when the modem is powered on, you do NOT
need to configure the phone number, etc. into the phone and may skip this section.
A

ir

L

ink

C
ommunications
Chan
Link
Reg
TxRx
RSSI
Err
Reset
Raven
Pw
r