Raven and PinPoint CDMA User Guide Version 1.12
AirLink Communications, Inc. Page 35 March 24, 2004
ATMLISTX1B=123.456.133.45
Continue until all the remotes are entered. There can be a total of 20 remote ID/Local
addresses entered into a Raven. Note a special build Raven Modbus Host version is
available that allows up to 100 entries in the list.
Remember to save the entries with AT&W.
If Using Dynamic IPs
The host Raven should be configured to report its current IP to a DDNS server so the
remote Ravens can use DDNS to obtain the host Raven’s IP. The remote Ravens can
then send their current IPs to the host Raven which will update the Modbus IP list
by matching the modem names.
Enter names into the IP list as follows:
ATMLIST27=remote1
or ATMLISTX1B=remote1
Continue until all the remotes are entered. There can be a total of 20 remote ID/Local
addresses entered into a Raven. Note a special build Raven Modbus Host version is
available that allows up to 100 entries in the list.
Remember to save the entries with AT&W.
The remote Ravens connected to the RTUs being polled, need to be set up for normal
UDP operation.
ATMD3 for Normal UDP operation
For Static IPs
Set ATS53= IP address/port number of the Raven connected to the Polling Host. If
the polling host Raven’s IP and port are 123.456.133.11 and 12345, set as follows:
ATS53=123.456.133.11/12345
ATS53=home1/12345
If Using Dynamic IPs
Set ATS53= name/port number of the host Raven. If the polling host Raven’s
*MODEMNAME and Device Port are home1 and 12345, set as follows:
ATS53=home1/12345
The remote Ravens need to be configured to update the host Raven with their current
IPs. Set up *IPMANAGER[1|2] to point to the host Raven:
*IPMANAGER[1|2]=home1
where home1 = *MODEMNAME in the host Raven.
*DOMAIN should match the domain of the host Raven. For example, if the DDNS
being used is eairlink.com, then *DOMAIN=eairlink.com. And the fully qualified
domain name the remote Raven would query is home1.eairlink.com.