Raven and PinPoint CDMA User Guide Version 1.12
AirLink Communications, Inc. Page 52 March 24, 2004
Command
Description
*IPMGRKEYn=[key][?] Sets the 128-bit key to use to authenticate the IP update
notifications. If the key’s value is all zeros, a default key will be
used. If all the bytes in the key are set to FF, then no key will be
used (i.e. the IP change notifications will not be authenticated).
AT*IPMGRKEY1 is used to set the key to use with
AT*IPMANAGER1, while AT*IPMGRKEY2 is used to the key
with AT*IPMANAGER2.
key = 128-bit key in hexadecimal [32 hex characters]
*IPMGRUPDATEn=x [?] Sets the number of minutes to periodically send an IP update
notification to the corresponding server. This will occur even if the
IP address of the modem doesn’t change. *IPMGRUPDATE1 is
used to set the refresh rate to *IPMANAGER1, while
*IPMGRUPDATE2 is used with *IPMANAGER2.
x = 0, 5-255 minutes. If the value is set to 0, then periodic updates
will not be issued (i.e. IP change notifications will only be sent
when the IP actually changes).
*IPPING=n [?] Set the period to ping (if no valid packets have been received) a
specified address (*IPPINGADDR) to keep the modem alive
(online).
Units are in minutes [1-255]. 0 [default] = Disable pinging.
*IPPINGADDR=IP/Name
[?]
Set the IP address (n.n.n.n) or valid internet domain name for the
modem to ping to keep itself alive (online). *IPPING must to be set
to a value other than 0 to enable pinging.
*MODEMNAME=[name][?]
(was *DOMAINNAME)
Name of the modem (up to 20 characters long) to use when
performing IP change notifications to IPManager. This name
should not be a fully qualified domain name, but simply the first
portion. The value in *DOMAIN provides the domain zone to add
to this name. For example if *MODEMNAME=mymodem and
*DOMAIN=eairlink.com, then the modem’s fully qualified
domain name is mymodem.eairlink.com.
NOTE: Only letters, numbers, hyphen ‘-‘, and periods can be used
in the modem name.
*MSCIUPDADDR=Name[/
Port]
Modem Status Update Address - where Name/Port is the domain
name and port of the machine where the modem status updates
will be sent. The modem’s status parameters are sent in an XML
format.
*MSCIUPDPERIOD=n [?] Modem Status Update Period - where x defines the update period
in minutes. n = 0-255. 0 = Disabled.
*NETCHAN?
Returns the current active channel number.
*NETIP?
Query the current public (network) IP address of the modem. This
is the IP address that was obtained from the embedded OEM
Modem, and is the address to which packets can be sent in order to
contact the modem from the Internet.
NOTE: This could be 0.0.0.0 if there is no current network IP
*NETOK
Checks wireless network connection
Responds OK if connected
Responds ERROR if not connected