Airlink Raven and PinPoint CDMA

Raven and PinPoint CDMA User Guide Version 1.12

11 PinPoint Vehicle Installation

This section covers installing a PinPoint CDMA modem into a vehicle in the most

optimum way possible, ensuring no future

11.1 Overview

Installing a PinPoint in a vehicle consists of:

• Choosing a location in the vehicle for the PinPoint

• Mounting the PinPoint

• Hooking up power to the PinPoint

• Routing the cables through the vehicle

• Positioning the antennas for good reception

• Connecting and securing cables to the PinPoint

Modem Antenna

GPS Antenna

PinPoint

(not to scale)

Note: Keep all cable lengths as short as possible during installation. Route

the cables in such a way so they are protected and will not cause

interference. Bundle and tie excess amounts if needed.

AirLink Communications, Inc. Page 60 March 24, 2004

Contents

Main Page Important Notice Safety and Hazards Limitation of Liability Page Raven and PinPoint CDMA User Guide Table of Contents Page Page Page Raven and PinPoint CDMA User Guide WARNING 1 Introduction 1.1 CDMA2000 1X 1.2 Raven Product Overview 1.3 PinPoint Product Overview 2 Network Connection A TS 3 Modem Configuration 3.1 Local Configuration Page 3.2 Modem Activation A ir L ink Page 3.3 Remote Configuration with Telnet Page Page 4 Windows Dial-Up Networking Setup 4.1 Add Windows Modem Driver 4.1.1 Setup Modem 4.1.2 Add Modem Driver Page Page 4.2 Windows Dial-Up Networking (PPP) Configuration Page Page Page Page Page Page Page 4.3 Making a 1xRTT Data Connection Page 5 Dynamic IP Addresses DB 5.1 IPManager and Dynamic DNS Updates 5.2 Using Names in the Modem, Domain Name Resolving Page 6 Serial Communication Modes 6.1 AT Mode 6.2 PPP Mode 6.3 PassThru Mode 6.4 UDP PAD Mode 6.4.1 UDP Auto Answer 6.4.2 Reliable UDP 6.4.3 Multicast UDP [Raven Only Feature] 6.5 TCP PAD Mode Page 6.8 SLIP Mode 6.9 Modbus/BSAP Configuration [Raven Only Feature] 6.10 Configuring the Polling Host Application Raven Configuring the Remote Ravens 7 PinPoint Notes 7.1 Low-power Mode 7.1.1 Effect on Modem State 7.2 Real-Time Clock Sync 7.3 Different Local and Remote Report types 7.4 RAP Poll Command 7.5 TAIP Emulation 7.6 NMEA Reports 8 PinPoint Specific AT Commands Page Page Page 9 Using AT Commands 9.1 CDMA Specific AT Commands 9.2 Raven and PinPoint AT Command Reference Page Page Page Page Page Page Page Page Page Page 10 Raven Installation Mounting the Raven Page Page RTU RAVEN BATTERY Raven and PinPoint CDMA User Guide Version 1.12 +- TNC AirLink Communications, Inc. Page 59 March 24, 2004 Lightening Arrestor Page 11.2 Mounting the PinPoint 11.3 Installing the Antennas 12 Raven CDMA Technical Specifications 12.1 Quick Look 12.2 Physical Characteristics 12.3 Power Specifications 12.4 Environmental 12.5 Status LED Display 12.6 RF Features 12.7 Application Interface Features Page 13 PinPoint CDMA Technical Specifications 13.1 Physical Characteristics: 13.2 Power Specifications: 13.3 Environmental: 13.4 Status LED Display: 13.5 RF Features: 13.6 Application Interface Features: 13.7 CDMA and Cellular Standards: 13.8 GPS Module