Raven and PinPoint CDMA User Guide Version 1.12
AirLink Communications, Inc. Page 45 March 24, 2004
Command
Description
DAE=n [?]
Disable AT Escape Sequence detection
n = 0: Enable +++ AT escape sequence detection.
n = 1: Disable +++ AT escape sequence detection.
En
Toggle AT command echo mode.
n = 0: Echo Off
n = 1: Echo On.
FM=n [?]
Friends Mode – Only allow specified IPs to access the modem
n = 0: Disable Friends mode
n = 1: Enable Friends mode – Only packets from friends will be
accepted (see below); packets from other IP addresses are ignored.
Fn=d.d.d.d [?]
Friends mode IP address
n = Friends list index [1 – 10]
d.d.d.d = IP address to be allowed to access the modem
255 = allow any number 0-255
Example: 166.129.2.255 allows access by all IPs in the range
166.129.2.0—166.129.2.255.
H
This command does nothing but does not cause an error either.
HOR=n [?]
Half-Open Response – In UDP auto answer (half-open) mode:
n = 0: No response codes when UDP session is initiated
n = 1: RING CONNECT response codes sent out serial link before
the data from the first UDP packet.
Note: Quiet Mode must be Off.
I[0]
Returns the product name.
I1
Returns AirLink modem’s firmware version, hardware ID, and
copyright.
I2
Returns the OEM Modem’s firmware version and relevant
hardware ID
I3
Returns the OEM Modem’s unique ID
M
This command does nothing but does not cause an error either.