Raven and PinPoint CDMA User Guide Version 1.12
AirLink Communications, Inc. Page 51 March 24, 2004
Command
Description
*DOMAIN=[name] [?]
(was *DOMAINSUFFIX)
Domain (or domain zone) which the modem is in. This value is used
during name resolutions if a fully qualified name is not provided
and also for DNS updates. This value can be up to 20 characters
long.
If *DOMAIN=eairlink.com, then when ATDT@remote1 is
entered, the fully qualified name remote1.eairlink.com will be
used to perform a DNS query to resolve the name to an IP address.
Note: Only letters, numbers, hyphen ‘-‘, and periods can be used in
a domain name.
*DPORT=n [?]
Sets or queries the modem’s Device Port. Valid values are 1-65535.
[See S110]
*DU=n [?]
Dial UDP Always
The dial command always uses UDP, even when using ATDT
n = 0: dial using the means specified [default]
n = 1: dial UDP always, even when using ATDT
NOTE: When this parameter is set you cannot establish a TCP
PAD connection.
*ENQ=n [?]
Outputs an ENQ [0x05] after the TCP CONNECT delayed by the
Delay Connect Response time [S221].
n = 0: Disabled (Default).
n = 1: Enables ENQ on CONNECT.
*HOSTPRIVMODE =n [?]
(was S300)
Set or query whether a private or public (network) IP is to be used
when the Host initiates a PPP connection to the modem.
n = 0 [default]: Public (network) IP Mode: When the Host initiates
a PPP connection, the host will be given the public IP that was
obtained from the OEM Modem. If the network issues a new IP, the
PPP connection will be closed (since the IP has changed) and has to
be re-initiated.
n = 1: Private IP Mode: When the Host initiates a PPP connection,
the host will be given the IP address specified in *HOSTPRIVIP.
The modem will then perform NAT-like address translation, which
shields the Host from network IP changes.
*HOSTPRIVIP =d.d.d.d [?]
(was S301)
Set or query the private IP address that is to be negotiated by the
PPP connection if *HOSTPRIVMODE =1.
*HOSTPEERIP =d.d.d.d [?]
(was S302)
Set or query the IP address that can be used to directly contact the
modem once a PPP connection is established. If this value is not
specified, 192.168.13.31 will be used.
NOTE: This is not normally used nor needed by user applications.
*IPMANAGERn=[name][?] Sets a domain name or IP address to send IP change notifications
to. Up to two independent IP Manager servers can be set, using
either AT*IPMANAGER1 or AT*IPMANAGER2. Updates to a
server can be disabled by setting that entry to nothing (i.e.
“AT*IPMANAGER1=”).