Aiwa XR-M88 manual Setting the Sleep Timer, Using the system while the timer is set

To check the specified time and source

Press the TIMER button while pressing the SHIFT button on the remote control. The selected source name, the timer-on time and the duration for the timer-activated period are displayed for 4 seconds.

To change the timer setting

Set the timer again from the beginning.

To cancel timer standby mode temporarily

Press the TIMER button repeatedly while pressing the SHIFT button on the remote control so that “TIMEROFF is displayed on the display.

To restore the timer standby mode, select “TIMER@ REC” or “TIMER@ PLAY” instead of “TIMEROFF?

Using the system while the timer is set

You can use the system normally after setting the timer.

Before turning off the power, prepare the source and the recording source, and adjust the volume and tone.

0 Timer play and timer recording will not begin unless the power is turned off.

IJConnected equipment cannot be turned on and off by the built- in timer of this system. Use an external timer.

SETTING THE SLEEP TIMER

SLEEP

The system can be turned off automatically at a specified time.

Use the remote control.

1 Press the SLEEP button while pressing the SHIFT button on the remote control.

2 Within 4 seconds, press the +4 or PP button to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.

Specified time SLEEP

To check the time remaining until the power is turned off

Press the SLEEP button once while pressing the SHIFT button on the remote control. The remaining time is displayed for 4 seconds.

To cancel the sleep timer

Press the SLEEP button twice while pressing the SHIFT button on the remote control so that “SLEEPOFF” is displayed.

ENGLISH 19