PROGRAMMED EDIT RECORDING
44,-
■
●REC
FUNCTION0-9.+10
|
|
| c’) |
| rfl |
| o |
Cassette deck | ● | ],,,] | |
|
|
I I b
SHIFT ●REC/
REC MUTE
Programmed edit function enables CD recording while checking the remaining time on each side of the tape as the tracks are programmed.
m
The programmed edit recording will not start from a point halfway in the tape. The tape must be recorded from the beginning of either side.
1 Load the tape into the cassette deck.
Load the tape with the side to be recorded on first facing upward.
2 Press the CD button on the remote control, or press repeatedly the FUNCTION button on the CD/ tape unit so that “CD” is displayed, and load the disc.
3 Press the CD EDIT button repeatedly while pressing the SHIFT button on the remote control until “EDIT” lights up and “PRGM” flashes on the display.
4 Press the numbered buttons to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a
●The 4+ and - buttons are also available to designate the tape length.
Tape side A (front side)
Maximum recording time for side A
5 Press the numbered buttons to program a track. Example: To select the 10th track, press the numbered
buttons +10 and O.
6Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time cannot be programmed.
Selected track
o Program number
Total number | of | Remaining time of side A |
programmed | tracks |
|
7 Press the CD EDIT button while pressing the SHIFT button on the remote control to select side B and program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (opposite side)
8 Press the ● REC button on the CD/tape unit to start recording.
To start recording with the remote control, press the ● REC/ REC MUTE button and within 2 seconds, press the * button. The tape is rewound to the beginning of the side facing upward, the lead segment is played through for 10 seconds, and recording starts, When recording on the side facing upward
(A) ends, recording on the opposite side (B) starts.
To stop recording
Press the ■ button. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press the CD EDIT button while pressing the SHIFT button on the remote control to select side A or B, and
press the - button repeatedly.
| Programmed |
Track number | track numbers |
Program number
To change the program of each side
Press the CD EDIT button while pressing the SHIFT button on the remote control to select side A or B, and press the ■ button to clear the program of the selected side. Then program tracks again.
To clear the edit program
Press the ■ button repeatedly so that “EDIT”disappears on the display.
m
Recording is inhibited if the erasure prevention tab on either side of the tape is broken off.
ENGLISH ~ 7
