Cisco Integrated Service Engine and WAE Configuration Manual

service-module integrated-service-engine status

To display configuration information related to software on the integrated-service-engine (ISE) side of

anetwork module, use the service-moduleintegrated-service-engine status command in privileged EXEC mode.

service-module integrated-service-engine slot/unit status

Syntax Description	slot	Slot number of the network module in the router chassis.
	/unit	Number of the daughter card on the network module. For ISE network
		modules, always use 0. The slash mark (/) is required between the slot
		argument and the unit argument.

Command Modes

Command History

Privileged EXEC

12.4(9)T	This command was introduced for ISE network modules.

Usage Guidelines	Use the service-module integrated-service-engine status command to perform the following tasks:
	• Display the ISE network module software release version
	• Check the ISE network module status (steady or down)

Examples	The following example displays information for an ISE network module that is installed in slot 1 of an
	access router:
	Router# service-module integrated-service-engine 1/0 status
	Service Module is Cisco Integrated-Service-Engine1/0
	Service Module supports session via TTY line 66
	Service Module is in Steady state
	Getting status from the Service Module, please wait..
	Cisco Application and Content Networking System Software 5.5.7 (b17 Apr 27 2007 08:56:37)
	Restarted at Sun Apr 1 15:32:38 2007
	The following example displays information for an ISE network module that is not running:
	Router# service-module integrated-service-engine 1/0 status
	Service Module is Cisco Integrated-Service-Engine1/0
	Service Module supports session via TTY line 258
	Service Module is trying to recover from reset/shutdown
	Service Module status is not available

Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments

26	OL-13140-02