show controllers
show controllers integrated-service-engine
To display controller information for
show controllers integrated-service-engine slot/unit
Syntax Description | slot | Slot number of the network module in the router chassis. |
| /unit | Number of the daughter card on the network module. For ISE network |
|
| modules, always use 0. The slash mark (/) is required between the slot |
|
| argument and the unit argument. |
|
|
|
Defaults
Command Modes
Command History
None
Privileged EXEC
ReleaseModification
12.4(9)T | This command was introduced for ISE network modules. |
|
|
Examples | Table 4 describes the fields shown in the command output. | ||
| Table 4 | show controllers | |
|
|
|
|
| Field |
| Description |
|
|
|
|
| Hardware |
| Description of the chip being used. |
|
|
| |
| IDB, FASTSEND | Address in router memory of the interface descriptor block (IDB) | |
|
|
| and the fastsend routine. |
|
|
|
|
| INSTANCE |
| |
|
|
| memory locations and current indexes of receive (Rx) and |
|
|
| transmit (Tx) rings in the router I/O memory. |
|
|
| |
| CONTROL AND STATUS | Control and status registers that are physically located on the chip | |
| REGISTERS (CSR) | itself and that are accessed by the CPU over the protocol control | |
|
|
| information (PCI) bus. |
|
|
| |
| PHY REGISTERS | Contents of the physical layer (PHY) registers. A PHY module is | |
|
|
| a device that interfaces to the physical Ethernet line and that is |
|
|
| located between the chip and the physical line. |
|
|
| |
| HARDWARE STATISTICS | Receive (Rx) and transmit (Tx) traffic statistics collected by the | |
|
|
| chip. |
|
|
| |
| INTERRUPT STATISTICS | Transmit (Tx), Receive (Rx), control, software, and flow control | |
|
|
| interrupt statistics collected by the chip. |
|
|
|
|
Configuring Cisco Access Routers and the
28 |
| |
|
