Cisco Systems NME-WAE Service-module integrated-service-engine reset, Usage Guidelines Examples

service-module integrated-service-engine reset

service-module integrated-service-engine reset

To reset the integrated-service-engine (ISE) network module hardware, use the service-moduleintegrated-service-engine reset command in privileged EXEC mode.

service-module integrated-service-engine slot/unit reset

Syntax Description	slot	Slot number of the network module in the router chassis.
	/unit	Number of the daughter card on the network module. For ISE network
		modules, always use 0. The slash mark (/) is required between the slot
		argument and the unit argument.

Defaults

Command Modes

Command History

None

Privileged EXEC

ReleaseModification

12.4(9)T This command was introduced for ISE network modules.

Usage Guidelines

Caution

Examples

At the confirmation prompt, press Enter to confirm the action or n to cancel.

Because you may lose data, use the service-moduleintegrated-service-engine reset command only to recover from a shutdown or failed state.

The following example resets the hardware on the ISE network module in slot 1:

Router# service-module integrated-service-engine 1/0 reset

Use reset only to recover from shutdown or failed state

Warning: May lose data on the hard disk!

Do you want to reset?[confirm]

Related Commands		Command	Description
		interface integrated-service-engine	Configures an interface for ISE network modules and enters
			interface configuration mode.
		service-module	Performs a graceful shutdown and reboot on the ISE network
		integrated-service-engine reload	module ACNS operating system.
		service-module	Gracefully shuts down ISE network modules.
		integrated-service-engine
		shutdown
		Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
	OL-13140-02			19