MANUAL TUNING
Q1“/,/ /’” -
II
FUNCTION ““...C;:..’;“-
DISPLAY
POWER 09 00
I TUNER/BAND
t ,
Press the TUNER/BAND button on the remote control (or the FUNCTION button on the CD/tape unit) repeatedly to select the desired band.
FM---AM+ r 1
(J
If the power is turned off, the previously tuned station will be played (Direct Play Function).
Press the + or - button to select a station.
Each time the button is pressed, the frequency changes. When a station is received, “TUNE”is displayed for 2 seconds. During FM stereo reception, (i(~)}] is displayed.
[[ml)]
About the level indicator
The above display automatically changes to the level indicator after 4 seconds.
The level indicator shows an approximate playback sound level.
To search for a station quickly (Auto Search)
Keep the ++ or > button pressed until the tuner starts searching for a station. After tuning in to a station, the search
stops. |
|
To stop the Auto Search manually, press the ++ or * | button |
●The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press the MONO button on the remote control. “MONO”appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, repeat the above again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this system in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the II button on the CD/tape unit.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see “PRESETTINGSTATIONS”) are cleared. The preset stations have to be set again.
To change the display
Press the DISPLAY button while pressing the SHIFT button on the remote control. With each press of the button, the display changes in the following order.
@Level indicator
1? @ Frequency of the tuned station (Example: FM 98.00MHz)
ENGLISH 9
