4 Connect the supplied antennas.
Connect the FM antenna to the FM 75 !2 terminals and the AM antenna to the AM LOOP terminals.
FM antenna
CONCERNING THE DISPLAY WINDOW’S DEMO DISPLAY
When the power cord is plugged into an electrical outlet for the first time after purchase, a demo display will appear in the display window. When the power is turned on, the demo display will end. When the power is turned off, the demo display will appear again. Until the clock is set, the demo display will appear whenever the power is turned off. (For setting the clock, see page 7.)
When the clock is set
The demo display can be seen by pressing the MODE button while pressing the SHIFT button on the remote control. This button is used also to dim the display and to set the system in the power economizing mode. See page 7 for detailed explanation.
5 Connect the AC cord to an AC outlet.
Do not
To stand the AM antenna on a surface
Fix the claw to the slot.
PLACING THE TWO UNITS SIDE BY SIDE
You may also place the CD/tape and the tuner/amplifier units side by side according to your preference.
In this case, make sure that the flat cable does not obstruct the ventilation openings, as shown below.
Always leave adequate clearance between the flat cable and the ventilation openings.
To position the antennas
FM feeder antenna:
Extend this antenna horizontally in a
AM loop antenna:
Position to find the best direction.
m
●Do not connect any speakers to the system other than the supplied ones.
●Do not leave objects generating magnetism near the speakers.
●Do not bring the FM antenna near metal objects or curtain rails.
●Do not bring the AM antenna near other optional equipment, the stereo system itself, the AC cord or speaker cords, since noise will be picked up.
●Do not unwind the AM antenna wire.
CONNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an outdoor antenna is recommended.
Connect the outdoor antenna to the FM 75 K2terminals.
\ To connect other optional equipment+ | page 20. | ] |
ENGLISH 5
