Aiwa XR-M88 Timer Play and Timer Recording, Prepare the source and recording destination, Remains

TIMER PLAY AND TIMER

RECORDING

rTIMER

IL,,

I POWER

SHIFT

The system can be turned on at a specified time every day with the built-in timer.

Make sure the clock is set correctly. (See page 7.)

Use the remote control.

1 Prepare the source and recording destination.

To listen to a CD, press the CD button on the remote control and load a CD.

To listen to or record from a radio broadcast, press the TUNER/BAND button on the remote control and tune in to a station.

To listen to or record from the connected equipment, press the AUX/MD button on the remote control repeatedly until the corresponding source appears on the display, and set the timer of the equipment to start playing at the required timer-on time.

2 Press theTIMER button repeatedly while pressing the SHIFT button on the remote control to display “TIMER @ PLAY” (for timer play) or “TIMER @REC” (for timer recording).

TIMER 6PLAY: for timer play

TIMER @REC: for timer recording

3 Within 4 seconds, designate the timer-on time by

pressing the + or ➤b button.

Pressing the < button once will move the time back by 1 minute, and pressing the > button once will advance the time by 1 minute.

Holding these buttons down will vary the time in 10-minute units.

4Press the 11 button.

When timer play is selected:

When timer recording is selected:

5Select the duration for the timer-activated period

with the - or - button.

Timer-activated period

The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.

6 Press the II button.

If 4 seconds elapse without the 11 button pressed, the timer set in steps 1 through 5 becomes effective.

7 For timer recording, load the tape to record on.

8 Press the POWER button to turn the system off

after adjusting the		volume and tone.	-
@or O=	remains	on the display after the power is turned
off (timer standby mode).

Note, however, that everything on the display will clear if the power economizing mode (see page 7) is activated. To confirm the timer standby mode, press the MODE button while pressing the SHIFT button on the remote control to turn off the power economizing mode.

When the timer-on time is reached, the system turns on and begins play (or recording) with the selected source.

If the volume level was set to higher than 21 when the power was turned off, it is automatically set to 21 when the system turns on by the timer.

18 ENGLISH