Aiwa XR-M88 manual Adjusting the Sound, ‘@GiiJ’EEiiiiP

ADJUSTING THE SOUND

R,,,.s.. . . .

/‘“\\

// ‘

I ‘\ Ii I VOLUME

T-BASS

IQsurround

}’ I

BBE LEQ

VOLUME

ADJUSTING THE VOLUME

Press the VOLUME buttons.

The volume level is shown on the display for 4 seconds. It can be set from O (minimum) to 30, and then MAX (maximum).

The volume is memorized even after the power is turned off. However, if the power is turned off when the volume is set to more than 21, it is automatically set to 21 the next time the power is turned on.

ENHANCING THE TREBLE SOUND

The BBE system enhances the clarity of high-frequency sound.

Press the BBE button on the remote control.

Each press on the BBE button lets you select one of the three levels, or the off position.

Lg]+m,,,“m”-’

F

ENHANCING THE BASS SOUND

The T-BASS system enhances the realism of low-frequency sound.

Press the T-BASS button on the remote control.

Each press on the T-BASS button lets you select one of the three levels, or the off position.

~[~p-m,,,

7 ‘@GiiJ’EEiiiiP

(OFF)

m

Low frequency sound may be distorted when the T-BASS system is used fora disc or tape in which Iowfrequencysound is originally emphasized. In this case, cancel the T-BASS system.

EQ (EQUALIZER)

This system provides the following three different kinds. ROCK: Powerful sound emphasizing treble and bass POP: More presence in the vocals and midrange JAZZ: Accented lower frequencies for jazz-type music

Press the EQ button on the remote control.

IJ

The graphic curve corresponding to the selected equalization mode appears on the display.

Q SURROUND SYSTEM

The Q SURROUND system built into this system uses only two speakers at the left and right to create an atmosphere that sounds as if you are surrounded by two front speakers and two rear speakers.

Press the Qsurround button on the remote control.

“QSURROUND ON” runs through the display, and the “QSURROUND” indicator appears.

To cancel the Q SURROUND effect

Press the Qsurround button on the remote control. “QSURROUND OFF” runs through the display, and the “QSURROUND” indicator goes off.

●The Q SURROUND system does not work in monaural mode.

●When the Q SURROUND system is on, the sound may be distorted at a higher volume. If this happens, turn the volume down.

SOUND ADJUSTMENT DURING

RECORDING

The output volume and tone of the speakers or headphones may be freely varied without affecting the level of the recording.

8 ENGLISH