Alamo FC-0001 manual Boom ARM Assembly, Hydraulic Line Inspection

(SG-15)

(SG-20)

OPERATION

OPERATION

BOOM ARM ASSEMBLY

•Inspect condition of each arm section weldment

•Ensure all pins are in place.

•Ensure all bolts and screws are properly installed.

•Check condition of teflon bushings at boom pivot points.

•Ensure each hydraulic cylinder is installed and retained correctly. Ensure the proper size pins are used to retain the cylinders in place and are secured properly. OPS-B- 0022_A

Never attempt to lubricate, adjust, or remove material from the Implement while it is in motion or while tractor engine is running.

HYDRAULIC LINE INSPECTION

•Check for hydraulic leaks along hoses, cylinders and fittings. IMPORTANT: DO NOT use your hands to check for oil leaks. Use a piece of heavy paper or cardboard to check for hydraulic oil leaks.

•Inspect the condition of the valve weldment.

•Ensure fitting is properly connected

•Inspect condition of nylon bushings.

OPS-B- 0023_A

Hydraulic Hoses

Do not operate this Equipment with hydraulic oil or fuel leaking. Oil and fuel are explosive and their presence could present a hazard. Do not check for leaks with your hand! High-pressure oil streams from breaks in the line could penetrate the skin and cause tissue damage including gangrene. To check for a hose leak, SHUT the unit ENGINE OFF and remove all hydraulic pressure. Wear oil impenetrable gloves, safety glasses and use Cardboard to check for evidence of oil leaks. If you suspect a leak, REMOVE the HOSE and have it tested at a Dealer. If oil does penetrate the skin, have the injury treated immediately by a physician knowledgeable and skilled in this procedure.

MAVERICK 3/09 Operation Section 3-12

© 2009 Alamo Group Inc.