(SG-10)

OPERATION

Never allow children or other persons to ride on the Tractor or Implement.

Falling off can result in serious injury or death.

Before transporting tractor between locations, idle the tractor engine, disengage the attached head, and wait for all head motion to come to a complete stop. Place the boom in its storage cradle rest support and then turn the joystick master switch to the OFF position.

Placing Boom Articulating Arm on Boom Arm Rest

 

 

 

 

 

 

 

 

 

 

• Extend the dipper section approximately half

 

BOOM ARM LUG REST

 

BOOM PIN REST

 

way out.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Bring the Lift to its full height and carefully swing the boom back until it is just positioned over the Boom Pin Rest. NOTE: There is a formed pin on the dipper section that fits onto the Boom Arm Lug Rest.

Lower the Lift until the Boom Arm Lug Rest on the Boom Pin Rest (this may take some re- adjustment of the dipper section).

Use your joystick to swivel the head to the lefthand side so that the head is aligned with the tractors width (this prevents the head from protruding from the side of the tractor).

Place the Master Switch in to the OFF position.

The boom is now in the transport position. To remove the boom from the Boom Rest, pull the Lift back and raise the boom about 6 inches. Then Swing the boom around to the desired position.

OPS-B- 0013

MAVERICK 3/09

Operation Section 3-49

© 2009 Alamo Group Inc.

OPERATION

Page 147
Image 147
Alamo FC-0001 manual Boom ARM LUG Rest Boom PIN Rest