MAINTENANCE
MAINTENANCE
STORAGE
Your mower represents an investment from which you should get the greatest possible benefit. Therefore, when the season is over, the mower should be thoroughly checked and prepared for storage so that a minimum amount of work will be required to put it back into operation for the next season. The following are suggested storage procedures:
1.Thoroughly clean the mower.
2.Lubricate the cutter as covered in Maintenance Section.
3.Tighten all bolts and pins to the recommended torque.
4.Check the mower for worn or damaged parts. Make replacements immediately.
5.Store the mower in a clean, dry place with the mower head resting on blocks.
6.Use spray
PROPER TORQUE FOR FASTENERS
The chart lists the correct tightening torque for fasteners. When bolts are to be tightened or replaced, refer to this chart to determine the grade of bolts and the proper torque except when specific torque values are assigned in manual text.
RECOMMENDED TORQUE IN FOOT POUNDS UNLESS OTHERWISE STATED IN THE MANUAL*
NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine oil. They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are used. This applies to both UNF fine and UNC coarse threads.
SL60 03/07 | Maintenance Section |
© 2007 Alamo Group Inc.
