Alcatel Carrier Internetworking Solutions TQBJ0223 manual Using the serial terminals, Basic format

Using the serial terminals

The main unit is equipped with SERIAL terminals located in its terminal section on the side, and this terminal is compliant with RS-232C. Also a serial output terminal is provided to enable plural projector control.

Examples of connection

Single projector		Plural projectors
<Terminal section on projector side>	PC	<Terminal section on Projector 1> <Terminal section on Projector 2>
D-Sub 9-pin (female)		D-Sub 9-pin	D-Sub 9-pin	D-Sub 9-pin	D-Sub 9-pin
		(female)	(male)	(female)	(male)
		PC
D-Sub 9-pin (male)
Communication cable		D-Sub 9-pin	D-Sub 9-pin	D-Sub 9-pin
		(male)	(female)	(male)
		Communication cable	Communication cable

Pin assignments and signal names

D-Sub 9-pin (female), external appearance

Serial input terminal

Pin No. Signal name	Description
	NC
TXD	Send data
RXD	Receive data
	Connected internally
GND	Ground
	NC
CTS	Connected internally
RTS
	NC

D-Sub 9-pin (male), external appearance

Serial output terminal

Pin No. Signal name	Description
	NC
RXD	Receive data
TXD	Send data
	NC
GND	Ground
	NC
RTS	Connected internally
CTS
	NC

Communication conditions (Factory setting)

Signal level	RS-232C compliant
Synchronization method	Start-stop synchronization
Baud rate	9 600 bps
Parity	None
Character length	8 bits
Stop bit	1 bit
X parameter	None
S parameter	None

Basic format

Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent in this order. Add parameters according to the details of control.

STX

A D

I 1

I 2

;

C1

C2 C3

:

P1

P2

…

Pn

ETX

	(2 bytes)		2	ID
			characters
					Semicolon		Colon		End
			(2 bytes)
					(1 byte)		(1 byte)		(1 byte)
Start		ZZ, 1 to 64 and 0A to 0Z				3 command		Parameter
(1 byte)		ID designate				characters (3 bytes)		(undefined length)

Attention

Note

•If a command is sent within about 60 seconds after the lamp is turned on, the response may be returned late or the command may be unable to be executed. Try sending and receiving commands after 60 seconds has elapsed.

•When sending several commands, be sure to wait for more than 0.5 seconds after receiving a response from the projector, and then send the next command. When sending commands without parameters, a colon (:) is not necessary.

•If a command cannot be executed, the projector will send an “ER401” response to the computer.

•If an invalid command is received, the projector will send an “ER402” response to the computer.

•Projector ID supported on the RS-232C interface is ZZ (ALL) and a group of 1 to 64 and 0A to 0Z.

•If a command is sent with a projector ID specified, the projector will return answer back only in the following cases: if it coincides with the projector ID,

ID specification is ALL and VPS-SYSTEM is the master, or ID specification is group and Group is the master.

•In the hexadecimal format, STX has the character code 02 and ETX the character code 03.

48