Alliance Laundry Systems P232156R9 manual UW Models with P-Control, Pre-Operating Instructions

Basic Installation/Operation

UW Models with P-Control

Pre-Operating Instructions

1.Turn on the main power source (circuit breaker or cut-off switch on wall). Models with the rotation sensor will display WE-6 Firmware ID Code “HRWC18” and later (i.e., “HRWC19”) after power up. For models without rotation sensor, proceed to step 1 of Operating Instructions.

2.Display shows size of machine and will flash “TEST?” and “SPEED” for 15 seconds.

3.Push Start keypad during the 15 seconds. Machine will test rotation sensing for 15 seconds.

4.Display will flash “POWER” and “WAIT” one time and will display “NEXT00.”

NOTE: If START keypad is not pushed while display flashes “TEST?” and “SPEED” or if rotation sensing fails, then display flashes “POWER” and “WAIT” before showing “NEXT00” for approximately 2 minutes.

Operating Instructions

1.When display shows “NEXT00,” washer- extractor is ready to be loaded with laundry.

2.On UW35 – UW125 models, use left hand to press and hold the door unlock button located on the lower right front of the control panel. Refer to Figure 21.

UW35 – UW125 MODELS

MD003J

Figure 21

WARNING

Do not operate machine in a cycle with program keymode switch in program position. Program keymode switch must be in run position at all times, except when editing or programming cycle or setup information.

W528

3.On UW35 – UW125 models, use right hand to turn door handle clockwise and swing the door left to open. Refer to Figure 22.

UW35 – UW125 MODELS

MD004J

Figure 22

36 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F232156