Alliance Laundry Systems UW35P2, UW35P3, UW60P2, UW60P3 Stop Routine, Balance Switch Detection, Temperature Display, Display Temp, NOTE: This feature applies to the UW60 only

Stop Routine

WARNING

NEVER insert hands or objects into basket until it has completely stopped. Doing so could result in serious injury.

SW012

A lengthy stop procedure ensures that the basket has adequate time to stop (from the machine’s highest speed) before the computer allows the door to be opened. This is an important safety feature.

During the normal stop routine at the end of the cycle, the computer will display “STOP” and turn off all outputs.

A 30-second shakeout (Wash 1) is included as part of the stop procedure. If additional shakeout is desired, see Programming a Spin Step in the Programming section of this manual.

The remainder of the stop routine is fixed at the following:

●low speed forward for 15 seconds

●pause for 5 seconds.

The computer will display “DONE,” and the door can be unlocked. The computer will continue to display “DONE” until the operator opens the door. Once the door is opened, the display will change to “NEXT.”

Operation

Balance Switch Detection

The washer-extractor is equipped with a balance switch detection system whereby the switch installed between the faces of the A-frame signals the computer to slow the washer-extractor when an out-of-balance load occurs during extract.

If the balance switch is tripped, the out-of-balance LED indicator located in the upper left corner of the first digit of the display will light and will remain lighted until the end of the extract step. This indicator tells the operator that an out-of-balance condition existed during an extract step. The washer-extractor will attempt to balance three times during an extract step.

If on the third attempt the out-of-balance condition continues, the washer-extractor will advance to the next step. (If the next step is another spin step, it will be skipped also.)

NOTE: This feature applies to the UW60 only.NOTE: The computer cannot advance through a drain step.

Temperature Display

The temperature display can be prompted to display in Fahrenheit or Centigrade. See Prompting the WE-6 in the Programming section of this manual.

To display temperature, press the Display Temp key. The display will read “F” or “C” and the temperature as long as the key is pressed. The computer will update the display automatically.

F232090