13.A natural next step in the cycle might be a warm rinse.

a.Press the Warm key and then the Rinse key. The display will read “WR0539.”

b.Press the Enter key. The display will read “M---S.”

c.Now enter the rinse duration in minutes and seconds. A spray rinse lasting 2 1/2 minutes is an appropriate choice.

Press key 2. The display will read “2M-00S.”

Now press key 3 and key 0. The display will read “2M-30S.”

14.Press the Enter key. The display will read “0639,” indicating that the computer is ready for step 6.

15.Step 6 in the cycle might be a warm fill to high level for a dilution rinse.

NOTE: The Rinse key controls a spin-sprayrinse. However, a dilution rinse is executed the same as a wash step without the addition of detergents.

a. Press the Warm key (key 3) twice to turn on two hot and two cold water valves to reduce fill time. The display will read “W-0639.” Then press the High key (key 3). The display will read “WH0639.”

b.Press the Enter key. The display will read “M---S.”

c.Enter the desired time for the computer to allow the machine to fill to high level. Five minutes is acceptable. Press key 5. The display will read “5M-00S.”

NOTE: If the machine does not fill in the amount of time programmed, the “FILL” alarm will be displayed.

16.Press the Enter key. The display will read “0739.”

17.Add a sour for step 7:

a.Press the Supply key and key 3. The display will read “S30739.”

b.Press the Enter key. The display will read “M---S.”

Programming

c. Enter the length of time for the supply to be activated. In this case, thirty seconds is adequate.

Press key 0 for minutes; press key 3 and then key 0 for seconds. The display will read “OM- 30S.”

18.Press the Enter key as always after programming a time duration. The display will read “0839,” indicating that the computer is ready for step 8.

19.For step 8, program the agitation action for the dilution rinse.

a.Press the Wash key and key 1 to program an action with normal reversing. The display will read “W10839.”

b.Press the Enter key. The display will read “M---S.”

c.Enter the time for the dilution rinse (three minutes).

Press key 3. The display will read “3M-00S.”

20.Press the Enter key. The display will read “0939,” indicating that the computer is ready for step 9.

21.The dilution rinse water must be drained.

a.Press the Drain key. The display will read “D10939.”

b.Press the Enter key. The display will read “M---S.”

c.Enter the length of time the computer will allow the machine to drain (one minute).

Press key 1. The display reads “1M-00S,” indicating that a one-minute step has been programmed.

22.Press the Enter key to move to step 10 of the cycle.

23.An extract step should now be programmed.

a.Press the Medium Speed key. The display will read “MS1039,” indicating a medium- speed spin.

b.Press the Enter key. The display will read “M---S.”

c.Enter the length of time for the medium-speed spin (one minute).

Press key 1. The display will read “1M-00S.”

F232090

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

27