Alliance Laundry Systems UW35P2, UW35P3, UW60P2, UW60P3 Transferring All Cycles from Simulator to Computer, Transferring One Cycle from Simulator to Computer

Programming

9.Press the ENTER key. The simulator display will flash “RECV” and “CYC” alternately. The computer display will flash “SEND” and “CYC” alternately.

When the two displays stop flashing, the transfer is complete.

Transferring All Cycles from Simulator to Computer

All keypad commands will be entered with the simulator keypad.

Use the following procedure to transfer all cycles contained in the memory of the simulator to the computer. (Transferring 39 cycles takes about 6 seconds.)

1.Connect the fiber optic cables between the simulator and the computer. Verify that the colored plugs on the ends of the optic cables match the colors of the ports on the simulator and on the washer-extractor’s control module (gray to gray, blue to blue).

2.Place both the simulator and the computer in the PROGRAM mode. The display on both will read “CYC00.”

3.Press the 0 key. The display will read “WRITE?”

4.Press the ENTER key. The display will read “ALL.”

5.Press the ENTER key again. The simulator display will flash “SEND” and “ALL” alternately. The computer display will flash “RECV” and “ALL” alternately.

When the two displays stop flashing, the transfer is complete.

Transferring One Cycle from Simulator to Computer

All keypad commands will be entered with the simulator keypad.

Use the following procedure to transfer one cycle contained in the memory of the simulator to the computer. (Transferring 1 cycle takes less than 1 second.)

1.Connect the fiber optic cables between the simulator and the computer. Verify that the colored plugs on the ends of the optic cables match the colors of the ports on the simulator and on the washer-extractor’s control module (gray to gray, blue to blue).

2.Place both the simulator and the computer in the PROGRAM mode. The display on both will read “CYC00.”

3.Press the 0 key. The display will read “WRITE?”

4.Press the ENTER key. The display will read “ALL.”

5.Press the 0 key. The display will read “CYC00.”

6.Press the ENTER key. The display will read “RCYC00.”

7.Now press the 2-digit code for the desired cycle number from the simulator.

8.Press the ENTER key. The display will read “WCYCcc.”

9.Now press the 2-digit code for the desired cycle number under which the cycle should be saved in the computer.

10.Press the ENTER key. The simulator display will flash “SEND” and “CYC” alternately. The computer display will flash “RECV” and “CYC” alternately.

When the two displays stop flashing, the transfer is complete.

42 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F232090