Programming
Programming a Soak Step
1.The computer must be in the PROGRAM mode, and the cycle programming sequence must be ready for the next step. (The previous step should have been a fill and/or supply step.)
2.Press the Soak key. The display will read “SKnncc.”
With machines equipped with auxiliary heat (optional steam or electric), it is possible to program a
To program a soak with temperature step use the following procedure:
a.Press the Heat key after pressing the Soak key. The display will read either “080Fcc” or “025Ccc,” depending on whether Fahrenheit or Centigrade is prompted.
b.Enter the temperature desired for the machine to maintain during the soak step. Three digits must be entered for the temperature. If the desired temperature is less than 100 degrees, the first digit should be 0. The valid temperature range is
3.Press the Enter key. The display will read
M.” Now assign the soak step the desired time in hours and minutes. During the soak step, no agitation will occur. The
4.Press the Enter key and go to the next step in the cycle.
Programming a Drain Step
1.The computer must be in the PROGRAM mode, and the cycle programming sequence must be ready for the next step.
2.Press the Drain key. The display will read “D- nncc.”
3.Press key 1 for a regular drain to sewer or a floor drain. The display will read “D1nncc.”
4.Press the Enter key. The display will read
S.” Now assign the time which will allow the machine to drain to empty.
This is an alarm time. The machine should drain in 30 seconds under normal conditions. The recommended drain time is one minute. Drain times of more than one minute are not recommended.
5.Press the Enter key and go to the next step in the cycle.
NOTE: When programming a drain step, it is important to select Drain 1. Drain 2 is not available on the UW60
Programming a Flush Step
When the Flush key is pressed, the drain will remain open and the basket will rotate in slow speed forward only. Water is added only through the door spray nozzle.
1.The computer must be in the PROGRAM mode, and the cycle programming sequence must be ready for the next step.
2.Press a water temperature key, either Cold, Hot, or Warm. If the Cold key is pressed, for example, the display will read
3.Press the Flush key. The display will read “CFnncc,” “HFnncc,” or “WFnncc,” depending upon the temperature selected.
4.Press the Enter key. The display will read
S.” Now assign the desired flush time in minutes and seconds.
5.Press the Enter key and go to the next step in the cycle.
38 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F232090 |