Programming

Programming Tutorial

The following procedure guides the programmer through a complete cycle and allows hands-on experience for programming cycles. The complete cycle is listed in the Tutorial Cycle table at the end of this section.

1.Locate the key-operated programming switch on the left side of the control module, viewed from the front. Insert the key and turn the switch to PROGRAM position. The display will read “CYC00.”

2.Press the Add Cycle key. The display will read “ACYC00.”

3.A two-digit number from 01 to 39 must be entered. Cycle number 39 is recommended because standard program versions use this short cycle for performing a chemical supply setup.

4.Press key 3, then key 9, then the Enter key. The display will read “CYC39.”

a.If the display alternately flashes “EXISTS” and “EDIT?,” press the Clear/Stop key. The display will return to “CYC39.”

b.Erase the existing cycle: Press the Erase Cycle key. The display will show “ECYC39.” Press key 3, then key 9, then the Enter key. The display will read “WAIT” for a few seconds and then “CYC39.”

c.Press the Add Cycle key. The display will read “ACYC39.” Press key 3, then key 9, then the Enter key. The display will show “0139.”

5.Enter the desired function for step 1. A natural choice might be hot fill to low level.

a.Press the Hot key and then the Low key. The display will read “HL0139.”

b.Press the Enter key. The display will read “M---S.”

c.Now enter the desired fill time. The recommended number of minutes is four. Press key 4. The display will read “4M-00S.”

6.Now press the Enter key. The display will read “0239,” indicating that the computer is ready for step 2 of cycle 39.

7.A natural choice for step 2 is the addition of a supply.

a.To add supply No. 1, press the Supply key and then key 1. The display will read “S10239.”

b. Press the Enter key. The display will read “M---S.”

c. Now enter the desired time in minutes and seconds for the supply valve to be turned on. Thirty seconds is the recommended time.

Press key 0 for minutes. The display will read “0M-00S.”

Now press key 3 and then key 0. The display will read “0M-30S,” indicating a supply time of thirty seconds.

8.Now press the Enter key. The display will change to read “0339,” indicating that the computer is ready for step 3.

9.If no other supply is required, the next step is to choose the type of wash desired and assign it a time. For example, one might choose a wash with standard reversing action (Wash 1) and a time of six minutes.

a.Press the Wash key and then key 1. The display will read “W10339.”

b.Press the Enter key. The display will read “M---S.”

c.Press key 6. The display will read “6M-00S,” indicating a wash step of six minutes.

10.Press the Enter key. The display will read “0439,” indicating that the computer is ready for step 4.

11.A drain step usually comes next.

a.Press the Drain key. The display will read “D10439.” (Applications using drain 2 are not available on 2-speed and 3-speed models.)

b.Then press the Enter key. The display will read “M---S.”

c.Enter the maximum time desired for the computer to allow the machine to drain to empty. The recommended time is one minute. Press key 1, and the display will change to “1M-00S,” indicating a drain step of one minute.

NOTE: The manufacturer does not recommend more than one minute for a drain step. If the machine does not drain in the amount of time programmed, the “EMTY” alarm will be displayed.

12.Press the Enter key. The display will now read “0539,” indicating that the computer is ready for step 5.

26

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232090