Programming
Editing a Cycle
To edit a cycle in memory or to change, add, or delete
astep:
1.Insert key into the program mode switch (located on the left side of the control module) and turn key to the PROGRAM position. The display will read “CYC00.”
2.Press the Edit Cycle key on the keypad. The display will read “DCYC00.”
3.Press the
4.Press the Enter key. The computer will search for cycle information for this cycle.
If no cycle information exists, the computer will flash “NCYC25” followed by “ADD?” To add this cycle, press the Enter key and proceed to the add cycle programming mode. If adding this cycle is not desired, press the Clear key. The computer will then return to the normal programming mode.
5.If cycle information does exist for cycle 25, the computer will display “0425,” for example, to indicate that cycle 25 has been run four times. To clear the count (reset it to zero), press key 0. The display will then show “0025.”
If clearing the count is not necessary or if it has just been cleared, press the Enter key. The computer will now display “HL0125,” indicating the first step of cycle 25.
6.Press the Advance key to move to the next step of the cycle.
7.Press key 0 to back up to the previous step.
8.To access further information pertaining to each step (for example, temperature and/or time), press the Enter key.
If the display shows a temperature, press the Enter key again to display the time.
9.Press the Enter key once more to advance to the next step.
10.At any time, the programmer can put the program mode switch in the RUN position, and the computer will return to normal running mode, provided all pertinent data for the last step edited is entered.
11.To change a step within the cycle, press the Clear key once while the computer is displaying the step to be edited. Enter the new step using the same procedure for adding a step to a new cycle.
NOTE: If, after the Clear key is pressed, it is decided that clearing the step is not desired, press the Edit Cycle key to restore the step. (This will work only if a step identification was displayed before pressing the Clear key. At other points in the
12.To change the time assigned to a step, press the Clear key once while the computer is displaying the unwanted time.
13.To add a step within the cycle, press the Add Step key. The step will be added into the cycle after the step presently displayed.
The computer will check to see if enough cycle memory is left in the cycle to add a step. (Each cycle may contain up to 51 steps.)
If the cycle memory for this cycle is full, the computer will display “CYFULL” for two seconds and return to displaying the previous step. If the computer sees no problem, the new step number will be displayed and the step may be added (as when adding a step to a new cycle).
NOTE: Use the following procedure with caution. It is not reversible.
14.To delete a step within a cycle, press the Clear key while the computer is displaying the step to be deleted. Press the Clear key again: the display will read “WAIT” while it is deleting the step.
The computer will then display the next step in the cycle, using the same step number as the deleted step.
15.If the Add Cycle key is pressed by mistake instead of the Edit Cycle key when the cycle number to be edited is entered, the display will flash “EXISTS” and “EDIT?” To recover, press the Enter key, and the computer will change to the edit mode.
32 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F232090 |