Erasing a Cycle in Memory

1.Insert the key into the program mode switch (located on the left side of the control module) and turn the key to the PROGRAM position. The display will read “CYC00.”

2.Press the Erase Cycle key. The display will read “ECYC00.”

3.Press the two-digit code for the cycle number that is to be erased. The display will read “ECYC25” if cycle 25 is chosen.

4.Press the Enter key. The display will read “WAIT” while it is erasing the cycle. The display will then return to “CYC00.” If there is no such cycle number in memory, the display will read “NCYC25.” To not erase a cycle, press the Clear key before pressing the Enter key. The display will return to “CYC.”

5.Return the program mode switch to the RUN position and remove the key.

Step Programming

Programming a Fill without Spray

This process is used in temperature-controlled fill steps where it is desirable to fill without spray and add water through the sump only.

To program a fill without spray, program a cold, hot, or warm fill to level as in a normal fill step; however, instead of pressing the Enter key after selecting the level, press the Auxiliary key. The computer will display a lower case “c,” “h,” or “w,” instead of the usual upper case “C,” “H,” or “W.” Press the Enter key now and program the time in the usual manner.

Programming a Fill Temperature

The table on the next page lists the required procedures to produce specific results. The table shows that when HIGH water level is programmed, the display indicator is “H.” When MEDIUM level is programmed, the display indicator is “M.” When LOW level is programmed, the display indicator is “L.” When OVERFLOW is programmed, the display indicator is “O.”

When the Warm key is pressed, the next key pressed will be another temperature key (Hot, Cold, or Warm) before selecting the level. Exceptions to this will be when RINSE or FLUSH steps are used: they require no level commands, and water is added through the door spray nozzle only.

Programming

Each time the Warm key is pressed, one hot and one cold water valve is turned on. The machine is equipped with four water valves (two fill and two spray); thus pressing the Warm key twice will turn on all four valves and reduce fill times.

Use the following procedure to program a fill to a specific temperature:

1.The computer must be in the PROGRAM mode, and the cycle programming sequence must be ready for the next step.

2.Press the Cold key. The display will read “C.” (HOT or WARM may be programmed instead to control inlet valves during the first three seconds of the fill. After the first three seconds, the fill is the same regardless of the prompt.)

3.Press the key representing the desired water level (Low, Medium, High, or Over). If High is pressed, for example, the display will read “CH.”

F232090

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

33