Allied Telesis 86241-06 manual PCR Module Trace Network affecting No

Patch 86241-06 For Rapier Switches 19

PCR: 02398 Module: IPV6 Network affecting: No

The following issues have been resolved:

•It was possible to assign the same network on different IPV6 interfaces

•The loopback address was being added to other interfaces

•The tunnel configuration was not showing correctly in IPV6 configuration commands

RIPv6 now sets the metric of routes for interfaces that are DOWN to 16, and immediately sends responses when the link status of VLAN interfaces changes.

PCR: 02399 Module: TRACE Network affecting: No

The Trace utility has been modified. Previously, Trace sent a group of packets at once and waited for multiple responses in order to assess the minimum, maximum and average time to cover a certain "hop distance" towards the target host. Now Trace sends each packet in each group individually, and waits either for a response or a time-out before sending the next packet in the group.

PCR: 02401 Module: IPV6 Network affecting: No

Neighbour discovery and PIM6 caused a fatal error when IPv6 was not enabled, or when the IPv6 feature license was not present. This issue has been resolved.

PCR: 02402	Module: SNMP, CORE, SHOW, Network affecting: No
	FILE

SNMP MIB support has been enhanced for CPU utilisation and file statistics. MIB support has been added for Allied Telesyn contact details and fast buffers.

PCR: 02403 Module: STP Network affecting: No

A watchdog timeout occurred when the command ENABLE STP PORT was executed. This issue has been resolved.

PCR: 02406 Module: IPV6 Network affecting: No

A Router-Alert option has been added. Also, the SHOW IPV6 MLD

INTERFACE command now works correctly.

PCR: 02409 Module: IPG Network affecting: No

A warning now appears when the DELETE IP INTERFACE command is executed before the DELETE DVMRP INTERFACE command.

PCR: 02410 Module: VRRP Network affecting: No

VRRP pre-empt mode was not working with advertisement updates of 1 second or more because this did not allow for interface start time on startup. Now a check is made to verify that interfaces are UP before timers are started.

PCR: 02411 Module: IPV6 Network affecting: No

The SHOW TCP command was not showing the listening status for IPv6.

Patch 86241-05 for Software Release 2.4.1 C613-10340-00 REV E