Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching Routers

15

PCR: 03232

Module: BGP

Level: 3

Values for the KEEPALIVE and HOLDTIME parameters in the ADD BGP PEER and SET BGP PEER commands were not interacting correctly. This issue has been resolved.

PCR: 03234

Module: IPG

Level: 3

The PURGE IP command did not remove ENABLE IP IGMP from the configuration. This issue has been resolved.

PCR: 03236

Module: IPG

Level: 3

IGMP queries were being sent after IGMP was disabled. This issue has been resolved.

PCR: 03237

Module: IPG

Level: 2

RIP Request packets for IPv4 were not being transmitted when the link came up or when the switch restarted. This issue has been resolved.

PCR: 03238

Module: SWI

Level: 2

When RIP interfaces were deleted, the IP routes learned through those interfaces were not timing out correctly. Now, all IP routes learned though a RIP interface are removed when the RIP interface is deleted, and no timeouts occur.

PCR: 03239 Module: QOS

Level: 2

QoS Traffic Class maximum bandwidth limiting was being overwritten by the port or trunk maximum bandwidth value. This should only happen when the Traffic Class maximum bandwidth has not been set manually with the CREATE QOS TRAFFICCLASS MAXBANDWIDTH parameter. This issue has been resolved.

PCR: 03240

Module: OSPF

Level: 2

A fatal error occurred when OSPF was under high load. This issue has been resolved.

PCR: 03245

Module: SWI, IPG, PIM

Level: 2

Multicast streams would not commence forwarding immediately due to IGMP packets initiated but not sent while a VLAN was changing from the DOWN to UP state. Also, multicast streams could be received while the VLAN was changing from DOWN to UP, causing a PIM Reverse Path Forwarding unicast route lookup failure. This was due to the unicast route being unusable as the VLAN was still considered down. These issues have been resolved.

PCR: 03247 Module: MVR

Level: 4

The Joins and Leaves counters in the SHOW IP MVR COUNTER command output did not count subsequent join or leave requests after the first join or leave. This issue has been resolved.

PCR: 03250

Module: SWI

Level: 4

The DELETE SWITCH FILTER command did not work properly when the ENTRY parameter was assigned a range with hyphen (“-”). This issue has been resolved.

Patch 86251-05 for Software Release 2.5.1 C613-10356-00 REV F

Page 15
Image 15
Allied Telesis 86251-05 manual PCR 03239 Module QOS Level, PCR Module SWI, IPG, PIM Level, PCR 03247 Module MVR Level