12 Patch Release Note
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
An additional check has been added to validate the MASK specified in an
ADD IP ROUTE command. The check tests that the mask is contiguous.
The SHOW CONFIG=ACC command was not showing the rscript file. This
issue has been resolved.
The SHOW IP MVR command output was showing dynamic members in
the incorrect column. This issue has been resolved.
The SHOW FFILE command output has changed. The first column that
listed where the file was stored has been removed. The title of the original
second column (now the first column) has been changed from “creator” to
“module”. The file format specifier has been altered from:
DDDD:MMMM\NNNNNNNN.TTT
to:
MMMM\NNNNNNNN.TTT
When changing the ACTION parameter between INCLUDE and
EXCLUDE on IPV6 filters the interface information was not preserved
between changes. The interface information is now preserved.
Switch trunk speed checks only checked for gigabit settings, not speed
capabilities. It is now possible for uplink modules which support 10, 000
and gigabit speed to attach to trunks where speeds are 10Mb/s or 100Mb/s.
The performance of IPv6 has been improved by introducing IPv6 flows.
IGMP Snooping did not use DVMRP messages to identify a port. This issue
has been resolved.
The output of the SHOW IP IGMP COUNTER and SHOW
IGMPSNOOPING COUNTER commands was incorrect. This issue has
been resolved.
When multicasting to a VLAN interface, if more than 2 DVMRP neighbours
existed on a single port, and any one of those neighbours was pruned, the
multicast data would stop flowing to the port. This happened even though
it was still required for the remaining DVMRP neighbours. This issue has
been resolved.
PCR: 03152 Module: IPG Level: 3
PCR: 03153 Module: ACC Level: 4
PCR: 03154 Module: PCI Level:
PCR: 03155 Module: FFS Level: 4
PCR: 03157 Module: IPV6 Level: 3
PCR: 03159 Module: SWI Level: 2
PCR: 03162 Module: IPV6 Level: 3
PCR: 03163 Module: IPG Level: 3
PCR: 03166 Module: IPG Level: 4
PCR: 03167 Module: DVMRP Level: 2