8

Patch Release Note

PCR: 03502

Module: IPG

Level: 3

The ENTRY parameter from the ADD IP FILTER command was not included in the output of the SHOW CONFIG DYNAMIC command. This issue has been resolved.

PCR: 03513

Module: IPG

Level: 3

An enhancement allows for the creation of static IGMP group memberships that do not time out. For details on this feature, see Static IGMP” on page 24.

PCR: 03515 Module: DHCP

Level: 3

DHCP was offering network and broadcast addresses to clients. This issue has been resolved.

PCR: 03517

Module: FIREWALL

Level: 3

An error was not returned if the SET FIREWALL POLICY RULE command was executed with PROTOCOL=1 when ICMP forwarding was turned on. This issue has been resolved so that an error is now displayed.

PCR: 03523

Module: FIREWALL

Level: 2

In some circumstances the checksum for the TCP header was set to zero.

This issue has been resolved.

PCR: 03526

Module: SWI

Level: 3

The Switch MIB did not show the correct dot1StpPriority value. This issue has been resolved.

PCR: 03531

Module: SWI

Level: 3

After creating a trunk group, the activity LEDs did not flash unless the configuration was used at reboot. This issue has been resolved so that the LEDs flash correctly whenever a trunk group is created.

PCR: 03468

Module: PIM

Level: 3

The source IP address in a PIM Register message was not the DR interface’s

IP address. This issue has been resolved.

PCR: 03533

Module: PIM

Level: 3

A forwarded PIM-DM state Refresh message did not update the metric and preference values. This issue has been resolved.

PCR: 03535

Module: IPG

Level: 2

IGMP Query messages were not sent after IGMP was disabled and then re- enabled. This issue has been resolved.

Patch 86251-05 for Software Release 2.5.1 C613-10356-00 REV F

Page 8
Image 8
Allied Telesis 86251-05 manual PCR 03515 Module Dhcp Level