Allied Telesis 86251-05 manual PPPoE Client on Vlan Interfaces

Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching RoutersSHOW IP IGMP DEBUG		35
	Figure 3: Router startup messages
	INFO: Self tests beginning.
	INFO: RAM test beginning.
	PASS: RAM test, 4096k bytes found.
	INFO: BBR tests beginning.
	PASS: BBR test, 128k bytes found.
	PASS: BBR test. Battery OK.
	INFO: Self tests complete
	INFO: Downloading router software.
	Force EPROM download (Y) ?
	INFO: Initial download succeeded
	INFO: Executing configuration script <boot.cfg>
	INFO: Router startup complete

Enter [Y] when the Force EPROM download (Y)? option appears.

6.Load the 86251-04.paz patch file, and set it as the preferred patch.

To load the 86251-04.paz file, use the command:

LOAD FILE=86251-04.paz

To make this the preferred patch, use the command:

SET INSTALL=PREFERRED PATCH=86251-04.paz

7.Reboot the switch using the RESTART REBOOT command.

Once the switch has restarted, check that the patch has restored the correct port map settings using the SHOW INTERFACE command.

PPPoE Client on VLAN Interfaces

PPPover Ethernet (PPPoE) has two modes of operation: Client Mode and Access Concentrator (AC) mode. PPPoE can now be configured on Ethernet and VLAN interfaces in both modes.

To configure PPPoE in Client Mode, the physical-interface parameter VLANn- servicename has been added, where servicename is 1 to 18 characters in length, and for a PPPoE client is usually supplied by the ISP providing the service. To specify that any service name is acceptable, you can use the special service name ANY.

The modified commands using the VLANn-servicenameparameter are:

■ADD PPP

■CREATE PPP

■DELETE PPP

■SET PPP

■SHOW PPP

The modified commands and parameters are described below. For all other unmodified parameters and commands refer to the PPP Chapter in your software reference manual.

Patch 86251-05 for Software Release 2.5.1 C613-10356-00 REV F