Remote control AMP ID codes

4Press the numeric buttons (F) to enter the four-digit remote control code for the input area you want to use.

CLASSICAL LIVE/CLUB ENTERTAIN MOVIE

1 2 3 4

STEREO ENHANCER SUR. DECODE NIGHT

5 6 7 8

9 0

Remote control AMP ID codes

Select one of the following codes to set the remote control AMP ID code for the input area you want to use.

AMP ID code

 

Remote

(remote control

Function

control AMP

setting)

 

ID

 

 

 

2001

To operate this unit using the

ID1

(initial setting)

default code.

(initial setting)

 

 

 

2002

To operate this unit using an

ID2

 

alternative code.

 

 

 

 

 

5Press DENTER to set the number.

“OK” appears in the display window (J) if setting

was successful.

“NG” appears in the display window (J) if the setting was unsuccessful. In this case, start over from step 1.

6Press TLEARN again to exit from the setup mode.

LEARN

Advanced setup

See page 89 for the operation of the advanced setup.

SCENE IR code setting SCENE IR

Use this feature to output the remote control signals at the REMOTE OUT jack automatically when this unit is in the SCENE mode.

Choices: ON, OFF

Select “ON” when the component connected to the REMOTE OUT jack is the Yamaha component and has the capability of the SCENE control signals. This unit automatically sends the remote control signals to the component.

Select “OFF” when the component connected to the REMOTE OUT jack is not the Yamaha component and does not have the capability of the SCENE control signals.

Note

If noises are output when you operate the SCENE function, set “SCENE IR” to “OFF”.

Bi-amplifier setting BI-AMP

Use this feature to activate or deactivate the bi-amplifier function (see page 14).

Choices: ON, OFF

Select “ON” if you want to activate the bi-amplifier function. “SUR.B L/R SP” is set to “NONE” automatically, and this unit outputs the front channel audio signals at the SURROUND BACK speaker terminals.

Select “OFF” if you want to deactivate the bi-amplifier function.

Note

When “BI-AMP” is set to “ON”, you can only select “FRONT B” or “NONE” in “EXTRA SP ASSIGN” (see page 64).

Video parameter reset V.RESET

Use this feature to initialize the “VIDEO CONV.”, “HDMI UP-SCALING”, “HDMI ASP” and “OSD SHIFT” settings in “DISPLAY SET” (see page 73). Choices: YES, CANCEL

Monitor check MON.CHK

Use this feature to activate or deactivate the monitor check function of this unit. When this parameter is set to “YES”, this unit receives the information of the available video signal resolutions from the video monitor connected via HDMI (see page 73).

Choices: YES, SKIP

OPERATION

ADVANCED

 

 

English

91 En

Page 93
Image 93
Yamaha DSP-AX861SE 91 En, SCENE IR code setting SCENE IR, Bi-amplifiersetting BI-AMP, Video parameter reset V.RESET