Advanced setup
See page 89 for the operation of the advanced setup.
■Speaker impedance SP IMP.
Use this feature to set the speaker impedance of this unit so that it matches that of your speakers.
Choices: 8Ω MIN, 6Ω MIN
•Select “8Ω MIN” to set the speaker impedance to 8 Ω .
•Select “6Ω MIN” to set the speaker impedance to 6 Ω .
SP IMP. | Speaker | Impedance level |
|
|
|
|
| If you use one set (A or B), |
|
| the impedance of each |
|
| speaker must be 8 Ω or |
|
| higher. |
| Front |
|
| If you use two sets (A and | |
|
| |
|
| B), the impedance of each |
8Ω MIN |
| speaker must be 16 Ω or |
|
| higher.* |
|
|
|
| Center |
|
|
| The impedance of each |
|
| |
| Surround | speaker must be 8 Ω or |
|
| higher. |
| Surround back | |
|
| |
|
|
|
|
| If you use one set (A or B), |
|
| the impedance of each |
|
| speaker must be 4 Ω or |
|
| higher. |
| Front |
|
| If you use two sets (A and | |
|
| |
|
| B), the impedance of each |
6Ω MIN |
| speaker must be 8 Ω or |
|
| higher. |
|
|
|
| Center |
|
|
| The impedance of each |
|
| |
| Surround | speaker must be 6 Ω or |
|
| higher. |
| Surround back | |
|
| |
|
|
|
■User presets PRESET
Use this feature to reset all the parameters of this unit to the initial factory settings (see page 98).
Choices: CANCEL, RESET
•Select “CANCEL” not to reset any parameters of this unit.
•Select “RESET” to reset the parameters of this unit.
Notes
•This setting completely resets all the parameters of this unit including the “SET MENU” parameters.
•The initial factory settings are activated next time you turn on this unit.
■Remote control AMP ID REMOTE AMP
Use this feature to set the AMP ID of this unit for remote control recognition. This feature is useful when you operate this unit and the other Yamaha receivers/ amplifiers in the same room separately.
Choices: ID1, ID2
•Select “ID1” when the remote control AMP ID code is set to “2001”.
•Select “ID2” when the remote control AMP ID code is set to “2002”.
Setting remote control AMP ID codes
You need to set the remote control AMP ID code for the remote control.
1Set the operation mode selector to LAMP or
LSOURCE.
2Press and hold TLEARN for about 3
seconds using a ballpoint pen or similar object and then press Dl / h repeatedly
until “L;AMP” appears in the display window (J) on the remote control.
PRESET/CH
LEARN
ENTER
A/B/C/D/E |
Notes
•Be sure to press and hold TLEARN for at least 3 seconds, otherwise the learning process will start.
•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, start over from step 1.
3Press DENTER.
The
control.
