Remote control features
2Press and hold TLEARN for about 3 seconds using a ballpoint pen or similar object.
The library name (ex. L;DVD) and the name of the
selected input area (ex. DVD) appear alternately in the display window (J) on the remote control.
LEARN
y
•You can set a remote control code of a different type of component to an input area. Press Dl / h repeatedly to
change the library (component category).
Library choices: L;DVD, L;DVR, L;LD, L;CD, L;CDR, L;MD, L;TAP (tape), L;TUN (tuner), L;AMP, L;TV, L;CAB (cable), L;SAT (satellite), L;VCR
•If you want to setup for another input area, press the input selector button, 
or 
, or press JSELECT k / n repeatedly to select the input area.
Notes
•Be sure to press and hold TLEARN for at least 3 seconds, otherwise the learning process will start.
•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, start over from step 2.
3Press DENTER.
The
Note
“0000” appears in the display window (J) if no code has been set.
4Press the numeric buttons (F) to enter the
For a complete list of available remote control codes, refer to “List of remote control codes” at the end of this manual.
CLASSICAL LIVE/CLUB ENTERTAIN MOVIE
1 2 3 4
STEREO ENHANCER SUR. DECODE NIGHT
5 6 7 8
90
5Press DENTER to set the number.
“OK” appears in the display window (J) on the
remote control if setting was successful.
“NG” appears in the display window (J) on the remote control if the setting was unsuccessful. In this case, start over from step 3.
y
If you continuously want to set up another code for another
component, press the input selector button (B) or 
, or JSELECT k / n repeatedly to select the component, then
repeat steps 2 through 5.
6Press TLEARN again to exit from the setup mode.
LEARN
7Press p or AV POWER to confirm whether you can control your component using the remote control.
POWER
orAV
y
If operation is not possible and the manufacturer of your component has more than one code, try each of them until you find the correct one.
Notes
•“ERROR” appears in the display window (J) on the remote control if you press a button not indicated in the respective step, or when you press more than one button simultaneously.
•The supplied remote control does not contain all possible codes for commercially available audio and video components (including Yamaha components). If operation is not possible with any of the remote control codes, program the new remote control function using the learn feature (see “Programming codes from other remote controls” on page 81) or use the remote control supplied with the component.
•Functions programmed using the learn feature take priority over remote control code functions.
