Remote control features
Clearing configurations
You can clear all changes made in each function set, such as learned functions, macros, renamed input area names and setup remote control ID.
■Clearing function sets
1Set the operation mode selector to LAMP or LSOURCE and then press TCLEAR by
using a ballpoint pen or similar object.
“CLEAR” appears in the display window (J).
AMP
SOURCE
TV
CLEAR
or
AMP
SOURCE
TV
Note
If you do not complete each of the following steps within 30 seconds, the clearing mode will be automatically canceled. In this case, start over from step 1.
2Press Dk / n to select the clear mode.
L;CD (etc.) (L; Name of an input area)
Clears all learned functions in the respective
| input area. The name of a component is shown |
| after a semicolon (;). Press an input selector |
| button to select the input area. |
L;AMP | Clears all learned functions for controlling the |
| amplifier functions of this unit. |
L;ALL | Clears all learned functions. |
M;ALL | Clears all programmed macros. |
RNAME | Clears all renamed source names. |
FCTRY | Clears all remote functions and returns the |
| remote to the factory settings. |
3Press and hold TCLEAR again for about 3
seconds.
“WAIT” appears in the display window (J). If
clearing was successful, “C;OK” appears in the display window (J) on the remote control.
CLEAR
y
Once you have cleared a learned function for a button, the button reverts to the factory setting (or to the manufacturer setting, if you have set remote control codes).
Notes
•“L;ALL” and “FCTRY” may take about 30 seconds to complete.
•“C;NG” appears in the display window (J) if clearing was unsuccessful. In this case start over from step 2.
•“ERROR” appears in the display window (J) if you press a button not indicated in the respective step, or if you press more than one button simultaneously.
