Yamaha DSP-AX861SE owner manual Playback, Basic procedure, 37 En, the desired input source

Playback

Caution

Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS.

y

To play DTS-encoded CDs when using a digital audio connection, set “DECODER MODE” in “INPUT MENU” to “DTS” before the playback (see page 72).

Before performing the following operations, set the operation mode selector on the remote control to LAMP.

Basic procedure

1Turn on the video monitor connected to this unit.

y

See page 40 to display the input source information on the video monitor.

2Rotate the 0INPUT selector (or press one of the input selector buttons (B)) to select

the desired input source.

The name of the currently selected input source appears in the front panel display for a few seconds.

Available input sources

VCR DVR V-AUX DTV/CBL DVD MD/CD-R TUNER CD PHONO

Currently selected input source

y

The corresponding input selector button on the remote control for the currently selected input source lights up for approximately 5 seconds after you press any buttons on the remote control, showing which source component is currently being operated.

3Start playback on the selected source component or select a broadcast station.

Refer to the operating instructions for the source component.

4Rotate 4VOLUME (or press KVOLUME +/–) to adjust the volume to the desired output level.

y

•See page 48 to adjust the level of each speaker.

•This does not affect the AUDIO OUT (REC) level.

•You can set the initial volume level and maximum volume level (see page 69).

5Rotate the 6PROGRAM selector (or press

one of the sound field program selector buttons (U) repeatedly) to select the desired

sound field program.

The name of the selected sound field program appears in the front panel display. See page 42 for details about sound field programs.

Currently selected sound field program

Note

Sound field programs cannot be selected when the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 38).

y

•Choose a sound field program based on your listening preference, not merely on the name of the program.

•When you select an input source, this unit automatically selects the last sound field program used with the corresponding input source.

•To display information about the currently selected sound field program in the OSD, see page 53 for details.

OPERATION BASIC

English

37 En