Yamaha DSP-AX861SE owner manual 97 En, During AUTO SETUP, After AUTO SETUP, Notes

Troubleshooting

During AUTO SETUP

Error message	Cause	Remedy	See
			page
E-1:NO FRONT SP	Front L/R channel signals are not detected.	Check the front L/R speaker connections.	13
E-2:NO SUR SP	A surround channel signal is not detected.	Check the surround speaker connections.	13
E-3:NO PRNS SP	A presence channel signal is not detected.	Check the presence speaker connections.	13
E-4:SBR->SBL	Only a right surround back channel signal is	Connect the surround back speaker to the	13
	detected.	LEFT SURROUND BACK SPEAKERS
		terminal if you only have one surround
		back speaker.
E-5:NOISY	Background noise is too loud.	Try running “AUTO SETUP” in a quiet	—
		environment.
		Turn off noisy electric equipment like air	—
		conditioners or move them away from the
		optimizer microphone.
E-6:CHECK SUR.	Surround back speakers are connected,	Connect surround speakers when you use	13
	though surround L/R speakers are not.	surround back speakers.
E-7:NO MIC	The optimizer microphone was unplugged	Connect the supplied optimizer microphone	28
	during the “AUTO SETUP” procedure.	to the OPTIMIZER MIC jack on the front
		panel.
E-8:NO SIGNAL	The optimizer microphone does not detect	Check the microphone setting.	28
	test tones.
		Check the speaker connections and	13
		placement.
E-9:USER CANCEL	The “AUTO SETUP” procedure was	Run “AUTO SETUP” again.	28
	cancelled due to user activity.
E-10:INTERNAL ERROR	An internal error occurred.	Run “AUTO SETUP” again.	28
After AUTO SETUP

Warning message	Cause	Remedy	See
			page
W-1:OUT OF PHASE	Speaker polarity is not correct. This	Check the speaker connections for proper	13
	message may appear depending on the	polarity (+ or –).
	speakers even when the speakers are
	connected correctly.
W-2:OVER 24m (80ft)	The distance between the speaker and the	Bring the speaker closer to the listening	—
	listening position is over 24 m (80 ft).	position.
W-3:LEVEL ERROR	The difference of volume level among	Readjust the speaker installation so that all	—
	speakers is excessive.	speakers are set in locations with similar
		conditions.
		Check the speaker connections.	13
		Use speakers of similar quality.	—
		Adjust the output volume of the subwoofer.	28
W-4:CHECK PRNS	“EXTRA SP ASSIGN” is set to	Check the presence speaker connections.	13
	“PRESENCE”, though the presence
		Set “EXTRA SP ASSIGN” to a setting	64
	channel signals are not detected.
		other than “PRESENCE”.

INFORMATION ADDITIONAL

Notes

•If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.

•If a warning message “W-1” appears, corrections are made, but they may not be optimal.

•If a warning message “W-2” or “W-3” appears, no corrections are made.

•If an error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.

English

97 En