Remote control features
5Press and hold the button you want to
program on the other remote control until “OK” appears in the display window (J) on
the remote control.
“NG” appears in the display window (J) on the remote control if learning was unsuccessful. In this case, start over from step 4.
| DTV/CBL | V | PHONO | 1 |
| TV | POWER |
| AUX/DOCK |
| |||||
|
| - |
|
|
|
|
|
| DVR VCR | TUNER | MULTI CH IN | 2 3 | SCENE | AV | POWER STANDBY |
SELECT | DVD | CD |
| 4 |
|
| POWER |
Other remote control
y
•If you want to program another function, repeat steps 4 and 5.
•If you continuously want to program another function for another component, press JSELECT k / n to select the
component, and then repeat steps 4 and 5.
Changing source names in the display window
You can change the name of the input source that appears in the display window (J) on the remote control if you want to use a different name than the factory preset. This feature is useful when you have set an input area to control a different component.
1Set the operation mode selector to LAMP or LSOURCE and then press an input selector button (B), 
or 
to select the input area you want to rename.
The name of the selected input area appears in the display window (J).
AMP |
|
|
|
|
SOURCE | PHONO | MULTI CH IN |
|
|
TV |
|
|
|
|
| TUNER | CD | ||
or |
|
|
|
|
| DTV/CBL | DVR | VCR | DVD |
AMP
SOURCE
TV
6Press TLEARN again to exit the learning mode.
LEARN
Notes
•“ERROR” appears in the display window (J) on the remote control if you press a button not indicated in the respective step, or when you press more than one button simultaneously.
•This remote control can learn approximately 200 functions. However, depending on the signals learned, “FULL” may appear in the display before you program 200 functions. In this case, clear unnecessary programmed functions to make room for further learning.
•Learning may not be possible in the following cases:
–when the batteries in the remote control for this unit or other components are weak.
–when the distance between the two remote controls is too great or too small.
–when the remote control infrared windows are not facing each other at the appropriate angle.
–when the remote control is exposed to direct sunlight.
–when the function to be programmed is continuous or uncommon.
2Press TRENAME using a ballpoint pen or similar object.
RENAME
Note
If you do not complete each of the following steps within 30 seconds, the renaming mode will be automatically canceled. In this case, start over from step 2.
